All moving parts are sealed in a permanent supply of lubricant or equipped with oilless bearings. Additional lubrication will not be necessary. Do not lubricate the door hinge. If the hinge makes noise,
replace the hinge.
If the unit is delivered on a cold day (below freezing) or is stored in an unheated room or area during the cold months, do not attempt to operate the washer until it has had a chance to warm up. Water from the previous cycle may remain.
Use only a damp cloth for cleaning the control panel. Some cleaning products may harm the finish on the control panel or damage the interior. DO NOT use products that contain alcohol on the control panel. Wipe dry the control panel after cleaning.
Wipe the washer cabinet as needed. If detergent, bleach, or other washing products are spilled on the cabinet, wipe immediately. Some products will cause permanent damage if spilled on the cabinet.
Do not use scrubbing pads or abrasive cleansers.
The drum will need no particular care although, it may need rinsing or wiping after an unusual load has been washed.
You can clean the outside of the door window with a household window cleaner.
When not in use, leave the door and dispenser drawer open slightly to keep them dry and prevent musty smells.
Running an occasional rinse cycle with bleach will help to avoid a musty smell in the washer drum.
To assure that the door seals against water leaks, wipe off periodically the following surfaces:
Usually, a mild soap solution will work. If there is an extreme build-up of minerals from a hard water supply, the surfaces may need to be cleaned with a lime removal chemical.
Hoses and other natural rubber parts deteriorate after extended use. Hoses may develop cracks, blisters, or material wear from the temperature and constant working high pressure.
Check all hoses monthly for any visible signs of deterioration. Replace immediately if any hose shows the signs of wearing listed above. Replace all hoses every five years.
Check the filter screens in the fill hoses for debris or damage every six months. Clean or replace them if necessary. If the washer is filling with water slower than usual, check the filter screens. Clean or replace them if necessary. Order the filter screens from the nearest authorized parts distributor.
To avoid possible property damage due to flooding, turn off the water supply to the washer during an extended period of inactivity. Leave the loading door and dispenser drawer open during extended periods of non-use to allow the wash drum and drawer to dry out and avoid a musty smell.
The washer’s pump has a trap that may collect foreign objects. The trap may need to be cleaned if water is draining slower than usual. To clean:
1. Disconnect the washer from the electrical supply.
NOTE: The pump may have some water in it. Use a rag or a container to catch water. If the wash drum is full of water, use a wet/dry shop vacuum to absorb the water.